Modifying a Backup Task¶
Scenario¶
This section describes how to modify the parameters of a created backup task on FusionInsight Manager to meet changing service requirements. The parameters of restoration tasks can only be viewed but cannot be modified.
Impact on the System¶
After a backup task is modified, the new parameters take effect when the task is executed next time.
Prerequisites¶
A backup task has been created.
A new backup task policy has been planned based on the actual situation.
Procedure¶
On FusionInsight Manager, choose O&M > Backup and Restoration > Backup Management.
In the task list, locate a specified task, click Configure in the Operation column to go to the configuration modification page.
On the displayed page, modify the following parameters:
Started
Period
Destination NameService Name
Target NameNode IP Address
Target Path
Max Number of Backup Copies
Maximum Number of Recovery Points
Maximum Number of Maps
Maximum Bandwidth of a Map
Note
After the Target Path parameter of a backup task is modified, this task will be performed as a full backup task for the first time by default.
Click OK to save the settings.